Changes

From SME Server
Jump to navigationJump to search
433 bytes added ,  15:23, 23 June 2020
no edit summary
Line 58: Line 58:  
=== Clock/frequency ===
 
=== Clock/frequency ===
 
As per suggestions in [http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1006427 this article from VmWare] and this one from [https://blogs.oracle.com/fatbloke/entry/speeding_up_your_linux_guests Oracle] on virtual Linux Guests, adjusting the guest Frequency will improve the guests speed.
 
As per suggestions in [http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1006427 this article from VmWare] and this one from [https://blogs.oracle.com/fatbloke/entry/speeding_up_your_linux_guests Oracle] on virtual Linux Guests, adjusting the guest Frequency will improve the guests speed.
 +
 +
{{Note box|It is suggested that this is not required for RHEL/CentOS 6}}
    
You can check if your guest server can benefit from these boot options:
 
You can check if your guest server can benefit from these boot options:
Line 96: Line 98:     
Some assumptions:
 
Some assumptions:
;Your main IP address:
+
;Your main Proxmox server IP address:
 
* IP address 62.20.20.250
 
* IP address 62.20.20.250
 
* Netmask 255.255.255.0
 
* Netmask 255.255.255.0
Line 104: Line 106:  
* 200.30.30.1
 
* 200.30.30.1
 
* 10:10:00:00:20:20 - you DID set the MAC didn't you ?
 
* 10:10:00:00:20:20 - you DID set the MAC didn't you ?
 +
 +
{{Note box|Proxmox now have a single IP you can use for all your VMs : 62.210.0.1}}
    
=== Proxmox configuration ===
 
=== Proxmox configuration ===
Line 123: Line 127:  
It doesn't matter which one is 0 or 1 as long as the settings are correct.
 
It doesn't matter which one is 0 or 1 as long as the settings are correct.
    +
{{Note box|You still cannot set a different gateway IP in the console configuration due to subnet checking.}}
 +
 +
After setup you can run:
 +
 +
config set GatewayIP 62.210.0.1
 +
 +
/etc/e-smith/events/actions/update-ifcfg
 +
signal-event post-upgrade;signal-event reboot
   −
{{Warning box| The following sections for v8 and v9 should no longer be relevant with the inclusion of the virtual adaptor code in SME server now}}
+
{{Warning box|The following sections for v8 and v9 should no longer be relevant with the inclusion of the virtual adaptor code in SME server now}}
    
=== SME V8 Configuration ===
 
=== SME V8 Configuration ===

Navigation menu