Tftp server

From SME Server
Jump to navigationJump to search


smeserver-tftp-server

Maintainer: Trevor Batley

Devel 10:
Contrib 10:
Contrib 9:
smeserver-tftp-server
The latest version of smeserver-tftp-server is available in the SME repository, click on the version number(s) for more information.


Description

This contribution adds a tftp server (tftp-server) to your smeserver (primarily used by workstations that are using the pxeboot protocol to retrieve boot images and parameters from the server).

It was produced to support my smeserver-thinclient contrib, but can be used independently.

Requires

  • smeserver >= 7.0
  • tftp-server >= 0.39

Installation

This contrib is held in the smecontribs repository, so the following commands will install on your smeserver.

yum --enablerepo=smecontribs install smeserver-tftp-server

Note: this will download and install the latest tftp-server from the Centos base repository, so if you don't have that repository ebnabled, please use the following command

yum --enablerepo=smecontribs --enablerepo=base install smeserver-tftp-server

Officially you should then need to apply the database changes etc., but this is not required for this package.

signal-event post-upgrade
signal-event reboot

The tftpd status is controlled via the Thin Clients server-manager panel if you have installed my smeserver-thinclient contrib.

If you haven't, you'll need to enable the tftp server and expand all the templates etc.

config setprop tftpd status enabled
signal-event tftpd-conf

If for any reason the tftp server isn't running, try:

/etc/init.d/supervise/tftpd restart

Defaults

You shouldn't need to play with any parameters (except status). The defaults and allowed values are listed below.

<prop> default <value> allowed Values description
status disabled enabled/disabled
access private private/public/localhost
log normal normal/verbose/disabled equivalent to -v or -vv or none
user nobody nobody/<user> default to nobody, any valid user id
privilege ro ro/rw read-only or read-write (rw equivalent to -c)
timeout default default/nnn timeout value in seconds (default is 900)
directory /tftpboot any directory
refuse* any tftp parameter e.g. blksize equivalent to -r blksize

These settings can be set/changed via

config setprop tftpd <prop> <value>
signal-event tftpd-conf

*refuse does not have a default entry in the configuration database. It can be added as above or removed via

config delprop tftpd refuse
signal-event tftpd-conf

Uninstall

yum remove smeserver-tftp-server tftp-server

Everything should be turned off, but if not, or you just want to make sure

/etc/init.d/tftpd stop

An error saying that /etc/init.d/supervise/tftpd does not exist should be returned

Source

The source for this contrib can be found in the smecontribs CVS on sourceforge.

Bugs

Please raise bugs under the SME-Contribs section in bugzilla and select the smeserver-tftp-server component or use this link .

IDProductVersionStatusSummary
12517SME Contribs10.0IN_PROGRESSSuperfluous Requires: ipsvd >= 0.11.1