Difference between revisions of "SystemMonitor"
m |
Unnilennium (talk | contribs) |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{Languages|SystemMonitor}} | {{Languages|SystemMonitor}} | ||
| + | {{Warning box|you should prefer [[sysmon]] instead of this contribs which is no more maintained}} | ||
== System Monitor for SME Server == | == System Monitor for SME Server == | ||
| Line 46: | Line 47: | ||
service systemmonitor start | service systemmonitor start | ||
| − | From verison 6, debug mode are present for the service so that remote debuging | + | From verison 6, debug mode are present for the service so that remote debuging is easer. |
To activate it, use the command: | To activate it, use the command: | ||
db configuration setprop systemmonitor debug debug | db configuration setprop systemmonitor debug debug | ||
| Line 57: | Line 58: | ||
---- | ---- | ||
| − | [[Category: Contrib]] | + | [[Category: Deprecated Contrib]] |
[[Category: Administration:Monitoring]] | [[Category: Administration:Monitoring]] | ||
Latest revision as of 07:56, 18 April 2021
System Monitor for SME Server
Maintainer
Description
- System Monitor provide graphics regarding server health.
- It adds a new panel in the server-manager.
Installation
RRDtool and perl-rrdtool are required
yum install rrdtool perl-rrdtool --enablerepo=smecontribs wget "http://www.vanhees.cc/index.php?name=CmodsDownload&file=index&req=getit&lid=300"
Sysstat are required but will be install using yum.
yum localinstall smeserver-system_monitor-x.y-z.noarch.rpm
Upgrade
All rrd base are automatically move to a backup directory /var/lib/rrdsm/backup/ If you update from version at least 5, you can use it again. Use the following command :
service systemmonitor stop rm /var/lib/rrdsm/*.rrd mv /var/lib/rrdsm/backup/*.rrd /var/lib/rrdsm/ service systemmonitor start
Uninstall
yum remove smeserver-system_monitor
Remove rrd data manually in /var/lib/rrdsm/ directory.
Usage
You can access system_monitor interface in the server-manager.
Known problems
After update, it could happen that parameters for the service disappear. Check existence with the following command:
db configuration show systemmonitor
If nothing appear, use the following command:
db configuration set systemmonitor service status enabled debug release service systemmonitor stop service systemmonitor start
From verison 6, debug mode are present for the service so that remote debuging is easer. To activate it, use the command:
db configuration setprop systemmonitor debug debug
Wait for about 5 minutes and go check file /var/log/systemmonitor You can send it to me, you'll find my address in the spec of RPM.
