653
edits
Changes
Jump to navigation
Jump to search
Line 132:
Line 132: − + + − [[Image:3.gui-installation-langselect.jpg|center|850px]]+ + + − − '''Step 4''': Select the defaults to use.
SME Server:Documentation:Administration Manual:Chapter5 (view source)
Revision as of 17:51, 12 April 2021
, 17:51, 12 April 2021→Installing the Software
[[Image:2.selectmenu1-tab-nolvm.jpg|center|850px]]
[[Image:2.selectmenu1-tab-nolvm.jpg|center|850px]]
'''Step 3''': Select the language you would like to use during the installation process.
'''Step 3''': Select the language you would like to use during the installation process. Select '''Done''' when finished.
[[Image:3.gui-installation-langselect.jpg|center|850px]]
'''Step 4a''': Enable the network if desired: required for net install. It is enabled using the switch on the right. Select '''Done''' when finished.
[[Image:9.installsummaryscreen-networksetupselecttutnon.jpg|center|850px]]
[[Image:9.installsummaryscreen-networksetupselecttutnon.jpg|center|850px]]
'''Step 4b''': Select the keyboard defaults to use. Select '''Done''' when finished.
[[Image:8.installsummarykeyboard.jpg|center|850px]]
[[Image:8.installsummarykeyboard.jpg|center|850px]]
{{Warning box| At this juncture the partioning scheme and treatment of multiple disks is automated by the customised Koozali install routines and any options you have set as above, eg 3 HDs equals RAID 1 with a hotspare: See the wiki [https://wiki.contribs.org/Raid Raid]. If you select the item "'''Installation Destination'''" those customised setups will be removed and the installer will fall back to the standard install of auto partitioning where the default CentOS scheme is used ie EFI if needed, boot and one huge LVM using all the remaining space on ALL disks are treated as one and a single large LVM. If you are sure of the process you may enter the "'''Installation Destination'''" section and setup your customised partioning, Raid, LVM and file system.
{{Warning box| At this juncture the partioning scheme and treatment of multiple disks is automated by the customised Koozali install routines and any options you have set as above, eg 3 HDs equals RAID 1 with a hotspare: See the wiki [https://wiki.contribs.org/Raid Raid]. If you select the item "'''Installation Destination'''" those customised setups will be removed and the installer will fall back to the standard install of auto partitioning where the default CentOS scheme is used ie EFI if needed, boot and one huge LVM using all the remaining space on ALL disks are treated as one and a single large LVM. If you are sure of the process you may enter the "'''Installation Destination'''" section and setup your customised partioning, Raid, LVM and file system.