19
edits
Changes
From SME Server
Jump to navigationJump to search
mLine 55:
Line 55: − + − + − + Line 121:
Line 121: + + + + + + + + + + + Line 130:
Line 141: + +
no edit summary
md: bind<cciss/c0d0p2>
md: bind<cciss/c0d0p2>
This tells me that I currently have 2 active partitions, p1 & p2, on drive c0d0 (controller 0, disk 0); if a secondary controller was added or used it would therefore be c1d0 (controller 1, disk 0).
This tells me that I currently have 2 active partitions, p1 & p2, on drive c0d0 (controller 0, disk 0); if a secondary disk is added or used it would therfore be c0d1 (controller 0, disk 1); if another SCSI controller is added or used it would therefore be c1d0 (controller 1, disk 0).
Logically my new drive should be on c0d1, & the linux device file to match should be in /dev/cciss, so:
Logically my new drive should be on c0d1 (controller 0, disk 1), & the linux device file to match should be in /dev/cciss, so:
fdisk /dev/cciss/c0d1 (use ? or m to get help)
fdisk /dev/cciss/c0d1 (use ? or m to get help)
Follow the prompts to add a Linux partition
Follow the prompts to add a Linux partition, I usuallu add a primary partition using the full capacity of the drive.
Use the w key to write the partiton table & exit from fdisk
Use the w key to write the partiton table & exit from fdisk
If you don't see a line for /dev/cciss/c0d1p1, something went wrong.
If you don't see a line for /dev/cciss/c0d1p1, something went wrong.
<br>Go back to step 2 and check if you followed all instructions correctly.
<br>Go back to step 2 and check if you followed all instructions correctly.
3.4 Create Quota files
As we enabled quotas in the fstab file for this drive we now need to create data files for the quota system to use
quotacheck -cug /mnt/backupdrive
now run the following to generate up to date quota values for the files on the filesystem
quotacheck -cug /mnt/backupdrive
We're all done, enjoy!
We're all done, enjoy!
To fix this issue I needed to create the folder /var/lib/rrd/drive_cciss/ & then restart Sysmon, the c0d1p1.rrd then magically appears in this folder.
To fix this issue I needed to create the folder /var/lib/rrd/drive_cciss/ & then restart Sysmon, the c0d1p1.rrd then magically appears in this folder.
This applies regardless of whether Sysmon is installed before or after the extra disk is added.
----
----
[[Category:Howto]]
[[Category:Howto]]
