sme8admin for SME Server
for a sme 7 version check sme7admin
for a sme 9 version check sme9admin
- sme8admin is a graphical monitor, alert raising, and services supervision tool for your SME 8 Server.
- It adds a headline + several subpages to the server-manager.
yum install smeserver-sme8admin --enablerepo=smecontribs
service mysql.init restart service sme8admind start
signal-event post-upgrade; signal-event reboot
Detect the sensors on your mainboard, (run as root)
For my mainboard, I just hit enter for all questions, which then uses the defaults which can be seen as CAPs. You will need to follow the instructions in order to add the detected sensors in rc.local to have them loaded on reboot.
Check installed versions
yum info installed smeserver-sme8admin yum info installed sysstat yum info installed hddtemp yum info installed perl-rrdtool yum info installed rrdtool
yum remove smeserver-sme8admin
If you connect to the SMEserver console by Putty ssh-client (or similar) you can copy and paste the commands (very convenient).
Good luck /Per
du -s and CPU
The du -s option allows you to have detailed information on the use of your hard drive. Unfortunately with the high volume of data in recent huge drives and/or with older slower CPUs, you should NOT use this option unless you want to see constant high CPU utilization, as this command will be launched every 5 minutes.
Disabling IMAP will fails webmail authentication. As a result, disabling IMAP will only work until new reboot or some event to be trigger. This will also make webmail fails until next reboot.
After reboot disabled IMAP will be set automatically to enabled and access to localhost.
Only released version in smecontrib are listed here.