859
edits
Changes
Jump to navigation
Jump to search
Line 36:
Line 36: − ===== NRPE configuration =====+ Line 80:
Line 80: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
no edit summary
==== NRPE configuration ====
Create a the NRPE configuration file /etc/nagios/nrpe.cfg. Use the nrpe.cfg provided by this conrib as a starting point.
Create a the NRPE configuration file /etc/nagios/nrpe.cfg. Use the nrpe.cfg provided by this conrib as a starting point.
Add the IP address of your central Nagios server to the variable ''allowed_hosts''. Use the local IP of the central Nagios server if you check the server over the local network or over a VPN, otherwise use the WAN IP.
Add the IP address of your central Nagios server to the variable ''allowed_hosts''. Use the local IP of the central Nagios server if you check the server over the local network or over a VPN, otherwise use the WAN IP.
allowed_hosts=127.0.0.1,192.168.1.1,192.168.99/24
allowed_hosts=127.0.0.1,192.168.1.1,192.168.99/24
=== Koozali v9 ===
I used this as a guide when installing nrpe on v9. I had to do a few extra steps as follows:
Add the EPEL repo https://wiki.contribs.org/Epel
yum --enablerepo=epel install nrpe
Create new template:
mcedit /etc/e-smith/templates/etc/hosts.allow/nrpe
Add the following and save:
{
$DB->hosts_allow_spec('nrpe');
}
Create the DB entry:
config set nrpe service HostsAllow "127.0.0.1 NAGIOS_CENTRAL_SERVER_IP" status enabled
Expand the template:
expand-template /etc/hosts.allow
Add your Nagios server IP to /etc/nagios/nrpe.cfg as above.
/etc/rc.d/init.d/nrpe restart
Make a softlink:
ln -s /etc/rc.d/init.d/e-smith-service S92nrpe
Upgrade/reboot:
signal-event post-upgrade;signal-event reboot
=== Uninstall ===
=== Uninstall ===